Frymaster H14 Series service manual Remove the element mounting screws

7-5: REPLACE HEATING ELEMENT (cont.)

5.	Remove the element mounting screws and	Front
	pull the element out of the frypot.
6.	Install the temperature probe and probe-
	securing components onto the replacement
	element.

7.Install the replacement element in the frypot and secure with the mounting screws removed in Step 5.

Back

Element-mounting screws and nuts (Inset Photo- back of tilt plate)

8.Route the element leads (terminals) to the rear of the fryer.

9.When replacing the right element (as viewed from the rear of the fryer), insert pin terminals into the corresponding pin-holes in the 6-pin connector. When all pin terminals have been fully inserted, close the connector by sliding the halves together until the tabs snap back into place (reverse procedure in Step 2).

Proper element-wire routing is essential to prevent wire chafing while raising and lowering elements.

7-7