![](/images/new-backgrounds/1168396/168396327x1.webp)
5.5 Ultra DMA Feature Set
3)The device shall resume an Ultra DMA burst by generating a DSTROBE edge.
b)Host pausing an Ultra DMA data in burst
1)The host shall not pause an Ultra DMA burst until at least one data word of an Ultra DMA burst has been transferred.
2)The host shall pause an Ultra DMA burst by negating
3)The device shall stop generating DSTROBE edges within tRFS of the host negating
4)If the host negates HDMARDY- within tSR after the device has generated a DSTROBE edge, then the host shall be prepared to receive zero or one
additional data words. If the host negates HDMARDY- greater than tSR after the device has generated a DSTROBE edge, then the host shall be prepared to receive zero, one or two additional data words. The
additional data words are a result of cable round trip delay and tRFS timing for the device.
5)The host shall resume an Ultra DMA burst by asserting
5.5.3.4Terminating an Ultra DMA data in burst
a)Device terminating an Ultra DMA data in burst
The following steps shall occur in the order they are listed unless otherwise specifically allowed (see 5.6.4.5 and 5.6.4.2 for specific timing requirements):
1)The device shall initiate termination of an Ultra DMA burst by not generating DSTROBE edges.
2)The device shall negate DMARQ no sooner than tSS after generating the last DSTROBE edge. The device shall not assert DMARQ again until after the Ultra DMA burst is terminated.
3)The device shall release DD (15:0) no later than tAZ after negating
DMARQ.
4)The host shall assert STOP within tLI after the device has negated DMARQ. The host shall not negate STOP again until after the Ultra DMA burst is terminated.
5)The host shall negate HDMARDY- within tLI after the device has negated DMARQ. The host shall continue to negate HDMARDY- until the Ultra DMA burst is terminated. Steps (4) and (5) may occur at the same time.
6)The host shall drive DD (15:0) no sooner than tZAH after the device has negated DMARQ. For this step, the host may first drive DD (15:0) with the result of its CRC calculation (see 5.5.5):