Fujitsu MHJ2181AT, MHK2120AT, MHK2090AT manual Information to be read by Identify Device command 3

Interface

Table 5.4 Information to be read by IDENTIFY DEVICE command (3 of 8)

Word		Value			Description
85	*12			Valid of command sets/function		*12
86	*13			Valid of command sets/function		*13
87	X’4000’			Default of command sets/function
88	X’xx1F’			Ultra DMA transfer mode *14
89	Set by a device			Security Erase Unit execution time (Unit: 2 min.)
90	X’0000’			Enhanced Security Erase Unit execution time (Unit: 2 min.)
91	(Variable)			Advance power management level
92	(Variable)			Master password revision
93	*15			Hardware configuration
94-127	X’0000’			Reserved
128	(Variable)			Security status	*16
129-159	X’0000’			Undefined
160-254	X’0000’			Reserved
255	X’xxA5’			Check sum (The 2 complement of the lower order byte
				resulting from summing bits 7 to 0 of word 0 to 254 and
				word 255, in byte units.)
	*1 Word 0: General configuration
		Bit 15:		ATA device = 0, ATAPI device = 1
		Bit 14-8:		Undefined
		Bit 7:		Removable disk drive = 1
		Bit 6:		Fixed drive = 1
		Bit 5-3:		Undefined
		Bit 2:		IDENTIFY DEVICE Valid = 0
		Bit 1-0:		Reserved
	*2 Word 1, 3, 6, 60-61
				MHJ2181AT	MHK2120AT	MHK2090AT	MHK2060AT
		Word 01		X’3FFF’	X’3FFF’	X’3FFF’	X’3080’
		Word 03		X’10’	X’10’	X’10’	X’0F’
		Word 06		X’3F’	X’3F’	X’3F’	X’3F’
		Word 60-61		X’21CAB00’	X’167CA00’	X’10D7900’	X’B30880’
	*3 Word 49:		Capabilities
		Bit 15-14:		Reserved

5-34 C141-E088-01EN