Interface
Table 5.4 Information to be read by IDENTIFY DEVICE command (7 of 8)
| Bit 1 = | '1': Mode 1 |
| Bit 0 = | '1': Mode 0 |
*15 WORD 93 |
|
|
Bits | ||
Bit 13: | '1' = CBLID- is a level higher than VIH. | |
| '0' = CBLID- is a level lower than VIL. | |
Bits | In the case of Device 1 (slave drive), a valid value is set. | |
| Bit 12: | Reserved |
| Bit 11: | '1' = Device asserts |
| Bit 10, 9: Method for deciding the device No. of Device 1. | |
|
| '00' = Reserved |
|
| '01' = Using a jumper. |
|
| '10' = Using the CSEL signal. |
|
| '11' = Other method. |
| Bit 8: | Reserved |
Bits | In the case of Device 0 (master drive), a valid value is set. | |
| Bit 7: | Reserved |
| Bit 6: | '1' = Device 1 is selected, Device 0 responds. |
| Bit 5: | '1' = Device 0, assertion of DASP- was detected. |
| Bit 4: | '1' = Device 0, assertion of PDIAG- was detected. |
| Bit 3: | '1' = Device 0, an error was not detected in the self- |
|
| diagnosis. |
| Bit 2, 1: | Method for deciding the device No. of Device 0. |
|
| '00' = Reserved |
|
| '01' = Using a jumper. |
|
| '10' = Using the CSEL signal. |
|
| '11' = Other method. |
| Bit 0: | Reserved |
*16 WORD 128 |
| |
