Lexmark IBM 9077 manual Enrmnode Command Options

Attention

Note that this command only affects the SDR, unless the -roption is used. The -roption should be issued only if endefadapter has been executed for the extension node.

When the GRF is properly configured and powered on, with the SP Switch Router Adapter inside, it periodically polls the Control Workstation for configuration data. The -roption or enadmin command is not required to activate the polling here.

2.4.2.2 The enrmnode Command

The enrmnode command is used to remove an extension node from the SDR DependentNode class and can also be executed using smit. The fast path for smit is delete_extnode. Its options are shown in Table 8.

Table 8. enrmnode Command Options

Flags	SMIT Option	Description
-r	Reset the	Specifies whether the enadmin command is to be
	extension node	activated after the enrmnode command
		completes. With this option the user does not
		have to explicitly issue the enadmin command. If
		the specification is yes, the -roption is part of the
		command. If the specification is no, the -roption
		is not part of the command.
	Node number	This is the node number the extension node
		logically occupies in the RS/6000 SP.

Attention

Note that this command only affects the SDR, unless the -roption is used. This command should be issued with a -rflag, because the enadmin command is not available for the extension node after enrmnode is executed, since the extension node has been removed from the SDR.

46IBM 9077 SP Switch Router: Get Connected to the SP Switch