#turned on.
#Setting the forward delay too small would result in temporary
#loops as the spannign tree algorithm converges. Setting this
#value too large results in longer partitions after the
#spanning tree reconfigures.
#
#The recommended value is 15 sec.
#forward_delay 15 seconds;
#
#maximum_age: This is the time value advertised by this bridge for
#deciding whether to discard spanning tree frames based on
#message age.
#
#If the selected max_age value is too small, then occasionally,
#the spanning tree will reconfigure unnecessarily, possibly
#causing temporary loss of connectivity in the network. If the
#selected value is too large, the network will take longer then
#necessary to adjust to a new spanning tree after a topological
#event such as restarting or crashing of a bridge or link.
#
#The recommended value is 20 sec.
#maximum_age 20 seconds;
#
#route_maximum_age: This parameter determines how often routes
#will be aged out of the learnt route table.
#
#Default : 300 seconds
#route_maximum_age 300 seconds;
#And last, hardwiring the forwarding table with
#specific MAC addresses to discard.
#
#Sink packets with the following destination
#addresses.
#
#discard 00:40:0b:0c:95:60 00:40:0b:0c:95:6a;
#Disable Spanning Tree for the group
#
#spanning_tree disabled
#} ;
#
#To create a bridge group with no ports in it, use the
#following NULL declaration:
#
#bridge_group bg0 {
# |
|
| ; |
# | }; |
|
|
# |
|
|
|
# |
|
|
|
#debug_level | 5; | # traces all events of level NOTICE and above | |
debug_level | 7 ; |
| |
#For FDDI Backbone test Chap.5.1.4.2 bridge_group bg0 {
port gf000 gf001 gf002 gf003;
};
