Lexmark IBM 9077 manual Enrmadapter Command, Endefadapter Command Options

2.4.2.3 The endefadapter Command

The endefadapter command is used to add or change the extension node adapter IP information in the SDR DependentAdapter object, and can be executed using smit. The fast path for smit is enter_extadapter. The command options are shown in Table 9.

Table 9. endefadapter Command Options

Flags	SMIT Option	Description
-a	Network	Specifies the IP address of the extension node.
	address
-m	Network	Specifies the netmask for the extension node.
	netmask
-r	Reconfigure	Specifies if the enadmin command is to be
	the extension	activated after the endefadapter command
	node	completes. With this option, the user does not
		have to explicitly issue the enadmin command. If
		the specification is yes, the -roption is part of the
		command. If the specification is no, the -roption
		is not part of the command.
	Node number	This is the node number the extension node
		logically occupies in the RS/6000 SP.

Attention

Note that this command only affects the SDR, unless the -roption is issued. The -roption should be issued only if the endefnode has been executed for the extension node.

When the GRF is properly configured and powered on, with the SP Switch Router Adapter inside, it periodically polls the Control Workstation for configuration data. The -roption or enadmin command is not required to activate the polling here.

2.4.2.4 The enrmadapter Command

The enrmadapter command is used to remove the SDR DependentAdapter object, and can also be executed using smit. The fast path for smit is delete_extadapter.

Router Node 47