Tally Genicom 6600 manual Appendix L ISET/USET Commands In PGL, Field Description

Appendix L ISET/USET Commands In PGL

ISET/USET Commands In PGL

The PGL graphics emulation now supports the ISET and USET commands. The ISET command can be used in NORMAL, CREATE, and EXECUTE modes and is used to select standard or user-defined character sets. User- defined character sets are created with the USET command in NORMAL mode. These commands have the following format:

<SFCC>ISET;n (Do not use the SFCC in CREATE mode)

<SFCC>USETn

ca;fa (one to sixteen ca;fa pairs)

END

Field	Description
<SFCC>	The special function control character.
n	The character set number. See the following table for
	descriptions of the character sets.
ca	The ASCII character cell hex address which will be
	replaced by the character represented by the font address
	(fa) parameter. The ca parameter must be equal to one of
	the following hex values: 21, 22, 23, 24, 25, 26, 40, 5B,
	5C, 5D, 5E, 60, 7B, 7C, 7D, 7E.
fa	The font address of a character that will replace the char-
	acter located in the character address (ca). This parameter
	must be between the hex values 20 and FF.

316