Tally Genicom 6600 manual Automatic Increment/Decrement

Chapter 5 Automatic Increment/Decrement

^IREPV,2,050^G

	This command causes Level A and all the following
	passes to be repeated twice vertically, with a
	spacing of 0.5 inches.
Level A	Printed data.

^IREPH,2,150^G

This command causes Level B and all other Graphics Passes within this level to be printed twice horizontally with a spacing of 1.5 inches.

^T003 Tabs the two columns of Level B data 0.3 inches from the left margin.

Level B Printed data.

^IREPV,3,020^G

this command causes Level C to print three times vertically with a spacing of 0.2 inches.

^T005 Tabs the two columns of Level C data 0.5 inches from the left margin.

Level C Printed data.

Automatic Increment/Decrement

Data items within a repeat sequence can be increased or decreased in predetermined amounts using the following increment or decrement syntax.

Command <Begin Repeat Command>^Yx+/-z^G<End Repeat Command>

Arguments

^Y	Turns ON the Automatic Increment/Decrement
	Mode.

xThe operand (the value you start with in any arithmetic operation). This value can be up to twelve characters long. Valid characters are 0 to 9, the capital letters A to Z, and spaces.

+/-	Select either the + or the - sign to determine
	whether the operand will be incremented or
	decremented, respectively.

zThe operator (the amount that is incremented or decremented at each step). This must be a numeric value up to 12 digits long. If the operator exceeds 12 digits or if it contains non-numeric characters (other than spaces), the operand remains unchanged.

^G Increment/Decrement Terminator

94