Tally Genicom 6600 manual Logo, Dpi

Chapter 9 PGL Commands

Table 24. CREATE LOGO Mode Command

Field	Function	Option/Modifier Selections
￿LOGO;	Initiates Create LOGO Mode.	Enter the current Special Function Control
		Character followed by LOGO, then end the
		entry with the parameter delimiter.
Name;	Enter the name of the Logo in this	LOGO names are allowed a maximum of
	field.	eight characters. The follownig ASCII
		characters may be used in form names:
		• Upper and lower-case A - Z
		(HEX 41 - 5A and 61 - 7A)
		• Number 0 - 9 (HEX 30 - 39)
		• Dollar sign $ (HEX 24)
		• Percent Sign % (HEX 25)
		• Dash - (HEX 2D)
		• At sign @ (HEX 40)
		• Braces { } (HEX 7B and 7D)
		• Parens ( ) (HEX 28 and 29)
		• Tilde ~ (HEX 7E)
		• Single quotes ‘ ‘ (Hex 60 and 27)
		• Exclamation point ! (HEX 21)
		• Pound sign # (HEX 23)
		• Amersand & (HEX 26)
		NOTE: Make sure your LOGO name is
		not identical to one that is already
		stored in memory. the new LOGO
		will replace the old LOGO if this
		happens.
VL;	Vertical size of the Grid at 72 DPI.	Enter a vlue from 1-252, followed by the
		parameter delimiter. Do not enter an
		amount larger than necessary to print the
		Logo.
HL	Horizontal size of the Grid at 60	Enter a vlue from 1-240, followed by the
	DPI.	parameter delimiter. Do not enter an
		amount larger than necessary to print the
		Logo.
Row#	Specifies which row in the Grid is	Enter each row that will be printed on a
	being defined for printing dots.	separate line, followed by the parameter
		delimiter. rows in the Grid are numbered
		sequentially from top to bottom of the Grid.

188