Tally Genicom 6600 manual Create Logo Command Normal, Using The Create Form Command

Create Logo Command (Normal)

Using The Create Form Command

This example shows how to design an employment application form for an Explosives Handler for a Demolition Company. To enter CREATE Mode and design a form called JobAppl, send the following command to your printer:

￿CREATE;JobAppl

To enter CREATE Mode and design the same form, send the following command to your printer:

￿CREATE;JobAppl

To enter CREATE Mode and assign a Form Length of 10 inches, send the following command to your printer:

￿CREATE;JobAppl;720

After entering CREATE Form Mode send the required commands to complete the form.

Now that you have informed the printer that you wish to CREATE a form called JobAppl that is 10 inches long, you can finish creating your form using the appropriate commands in the CREATE Form Mode.

Create Logo Command (Normal)

This command allows you to create logos for your forms. It initiates the Logo CREATE Mode, which enables you to create and store logos that will be called in CREATE Mode for use in creating forms. Logos are defined using specific dot placement within a grid.

This command names the logo then specifies a grid size for the logo and which dot positions within the grid will be printed. The grid is 72 DPI vertically and 60 DPI horizontally. The maximum size of the grid is 252 dot rows (3.5 inches) by 240 dot columns (4 inches). When defining the grid, it is best not to exceed the actual requirements needed to produce the logo. For example, if your logo is going to be 1 inch high by 1.5 inches tall, the grid would be the same size in dots (72 by 90). The basic command for creating a logo is:

187