Tally Genicom 6600 manual Vertical Line Command, Command Specifier Enter Vert

Horizontal And Vertical Line Commands (Create)

Table 29. Horizontal Line Command

Field	Function	Option/Modifier Selections
STOP	Command Terminator.	Enter STOP and the printer waits for a new
		command. Leave STOP out and the
		printer will wait for another Horizontal Line
		Command.

Vertical Line Command

Table 30. Vertical Line Command

Field	Function	Option/Modifier Selections
VERT	Command Specifier.	Enter VERT

The following parameters define print location and line thickness of a vertical line. The SR, SC, and EC parameters control placement, length, and thickness of vertical lines on a form. Whether in columns or dots depends on the SCALE Command. You may also use the XX.YY format for plotting duplication print locations explained earlier in the Standards Section.

LT;	Dictates the line thickness.	Vertical line thickness is based on dot
		increments (1/60”), then end the entry with
		the parameter delimiter. Line thickness is
		only limited by specifications.
SC;	Plots the starting COLUMN of the	Enter a value ranging from 1 to one less
	line.	than the maximum form width and the
		parameter delimiter.
SR;	Plots the starting ROW of the line.	Enter a value ranging from 1 to one less
		than the maximum form length and the
		parameter delimiter.
ER	Plots the ending ROW of the line.	Enter a value ranging from 2 to one less
		than the maximum form length.
STOP	Command Terminator.	Enter STOP and the printer waits for a new
		command. Leave STOP out and the
		printer will wait for another Vertical Line
		Command.

195