Using The Corner Command

Using The Corner Command

The corner command is used and set up similar to the BOX Command, with a few additional parametres. Use the same basic program for this parameter and add two specifications for controlling arm lengths. Create a set of corner frames on our form with the same starting and ending points (SCALE = DOT) used in the BOX program presented previously, and add arm lengths of 30 dots. The finished program would be:

~RESET

~CREATE;CORNER

SCALE;DOT CORNER 3;1;1;288;240;30;30 3;22;19;267;222;30;30 3;43;37;246;204;30;30 3;64;55;225;186;30;30 3;85;73;206;168;30;30

STOP

END ~EXECUTE;CORNER ~NORMAL

Figure 7. Corner Coordinates

185

Page 185
Image 185
Tally Genicom 6600 manual Using The Corner Command