Tally Genicom 6600 manual Block Character Fonts, Cpi

7.5 CPI

•Second Graphics Pass - ^M0303040^KH^KFOPTION^KF^KH^-

^KH	Toggles Half-Tone Mode ON and defaults to last
	pattern selected (EA).
^KF	Toggles ON Half-Dot Mode.
OPTION	Data printed with the selected pattern (EA) in Half-
	Tone/Half-Dot Mode.
^KF	Toggles OFF Half-Dot Mode.
^KH	Toggles OFF Half-Tone Mode.

Block Character Fonts

Block character fonts are created from the block character set in four graphic orientations, and are available in the following sizes:

•7.5 CPI block characters, 0.2 inches high.

•10 CPI block characters, 0.1 inch high.

•12 CPI block characters, 0.1 inch high.

•15 CPI block characters, 0.1 inch high.

7.5CPI

The 7.5 CPI character set is 2/10 inches high and 0.15 inches wide (0.51 cm high by 0.38 cm wide). All characters in this set are printed in upper case, even if the characters received from the host are lower case.

Command ^{M,U,V,E}0000jjD<data>^-

Arguments

^{M,U,V,E}	One of four Graphics Pass orientations (^M for
	horizontal, ^V for clockwise rotation, ^E for
	counterclockwise rotation, or ^U for upside down
	and reverse order of characters.)
0000	A height/width value of 0000 specifies 7.5 cpi
	characters.
jjd	Justification values in increments of 0.1 inches
	(0.25 cm) and dot rows as discussed in the
	Graphics Pass Command description below. This
	field may be omitted entirely if the justification value
	is zero.
<data>	The characters to be printed.

Example: The Graphics Pass ^M00000007.5 CPI CHARACTERS^- prints:

37