Tally Genicom 6600 manual Create Corner Frames Create

Create Corner Frames (Create)

Create Corner Frames (Create)

This command allows you to crate Corner Frames for your forms. Similar to the BOX command, you define starting and ending points but in addition, you specify the length of the horizontal and vertical arms of each corner frame. The basic command for creating Corner Frames is:

Table 22. Corner Command

Field	Function	Option/Modifier Selections
CORNER	This is the command specifier.	Enter CORNER
	Using the following parameters
	creates a set of corners around a
	specified area of the form at a
	specific line thickness and length of
	vertical and horizontal arms of
	each corner.
LT;	Dictates the line thickness.	Line thickness is based on dot increments
		(1/72”) horizontally and vertically. Line
		thickness is only limited by your
		specifications. Do not forget the parameter
		delimiter.

The SR, SC, ER, and EC parameters use the same methods for defining the CORNER Print area. Whether in columns or dots depends on the SCALE Command. You may also use the XX.YY format for plotting duplication print locations explained earlier in the Standards Section.

SR;	Plots the starting ROW of the	Enter a value ranging from 1 to one less
	corner.	than the maximum form length and the
		parameter delimiter.
SC;	Plots the starting COLUMN of the	Enter a value ranging from 1 to one less
	corner.	than the maximum form width and the
		parameter delimiter.
ER;	Plots the ending ROW of the	Enter a range ranging from 2 to one less
	corner.	than the maximum form length and the
		parameter delimiter.
EC	Plots the ending COLUMN of the	Enter a value ranging from 2 to one less
	corner.	than the maximum form width.

The VL and HL parameters specify the arm length of each corner piece in dots or characters depending on the SCALE Command. You may also use the XX.YY format.

183