Tally Genicom 6600 manual Create Form Command Normal, PGL Commands

Chapter 9 PGL Commands

Create Form Command (Normal)

This command is used to enter CREATE Form Mode. The command structure for entering CREATE Mode is:

Table 23. Enter CREATE Mode Command

Field	Function	Option/Modifier Selections
￿CREATE	Indicates CREATE Mode.	Enter the current Special Function Control
		Character followed by CREATE.
;Name	Enter the name of the form in this	Form names are allowed a maximum of
	field.	eight characters. The follownig ASCII
		characters may be used in form names:
		• Upper and lower-case A - Z
		(HEX 41 - 5A and 61 - 7A)
		• Number 0 - 9 (HEX 30 - 39)
		• Dollar sign $ (HEX 24)
		• Percent Sign % (HEX 25)
		• Dash - (HEX 2D)
		• At sign @ (HEX 40)
		• Braces { } (HEX 7B and 7D)
		• Parens ( ) (HEX 28 and 29)
		• Tilde ~ (HEX 7E)
		• Single quotes ‘ ‘ (Hex 60 and 27)
		• Exclamation point ! (HEX 21)
		• Pound sign # (HEX 23)
		• Amersand & (HEX 26)
;FL	This parameter sets the Form	Enter 0 to set the Form Length to end
Form Length	Length in three ways:	automatically after the longest element.
	• Automatic form length	Enter a value from 1 - 65,535 dot rows to
		set the Form Length to a specified amount.
	• Specific form length in dot
		To compute the desired number of dot
	rows.	rows multiply length in inches by 72. To set
	• Default form length in dot rows	form length to the default (792 dot rows)
	(Also see LFORM 6 and LFORM 8	do not enter a value in this field.
	Commands)

186