Tally Genicom 6600 manual Horizontal And Vertical Line Commands Create, Horizontal Line Command

Chapter 9 PGL Commands

Horizontal And Vertical Line Commands (Create)

In addition to boxes and corners, you can print horizontal and vertical lines on your forms. The following commands control location, length, and thickness of horizontal and vertical lines.

Horizontal Line Command

Table 29. Horizontal Line Command

Field	Function	Option/Modifier Selections
HORZ	This is the command specifier. The	Enter HORZ
	following parameters define print
	location and line thickness of a
	horizontal line.
LT;	Dictates the line thickness.	Horizontal line thickness is based on dot
		increments (1/72”). Line thickness is only
		limited by your specifications.
HE	Horizontal expansion amount.	Enter a value specifying the desired
		expansion factor, then end the entry with
		the parameter delimiter. Valid selections
		range from 0-113. A selection of 0 returns
		you to standard size characters.

The SR, SC, and EC parameters control placement, length, and thickness of horizontal lines on a form. Whether in columns or dots depends on the SCALE Command. You may also use the XX.YY format for plotting duplication print locations explained earlier in the Standards Section.

SR;	Plots the starting ROW of the line.	Enter a value ranging from 1 to one less
		than the maximum form length and the
		parameter delimiter.
SC;	Plots the starting COLUMN of the	Enter a value ranging from 1 to one less
	line.	than the maximum form width and the
		parameter delimiter.
EC	Plots the ending COLUMN of the	Enter a value ranging from 2 to one less
	line.	than the maximum form width.

194