#following formats:
#
#Ethernet or FDDI: xx:xx:xx:xx:xx:xx
# | where ’xx’ are hexadecimal digits. |
# |
|
#
#HIPPI:
# | Example: 0x03000555 for logical address x’555. |
# |
|
#
# | ATM: | vp/vc | VPI/VCI for PVCs |
# |
| where ’vp’ and ’vc’ are decimal integers | |
# |
| xx.xx.xx. . .xx.xx.xx.xx | NSAP address |
# |
| where ’xx’ are hexadecimal digits. | |
############# | Add your configuration following this line ############ |
#This is the HIPPI Interface from Chap.7.3
#This is on grf16, 10.50.1.2 and 0x03666fc0 is grf4
# grf4 has a line | like gh0?0 10.50.1.1 | 0x03555fc0 | |
gh080 | 10.50.1.2 | 0x03666fc0 |
|
B.6 /etc/gratm.conf
In this file, the parameters for ATM (OC-3c or OC-12c) are set.
#
#NetStar $Id$
#gratm.conf - GigaRouter ATM Configuration File
#
#This file is used to configure GigaRouter ATM interfaces.
#Statements in this file are used to configure ATM PVC’s,
#signalling protocols, arp services, and traffic shapes.
#gratm(8) uses this file as input when it is run by grinchd(8)
#whenever an ATM media card boots to configure the card.
#
#
#gratm.conf is divided into five sections:
#The Service section is where ATM ARP services are defined (entries
#defined in this section are referenced from the Interface section
#of this file to define which ARP service an interface should use).
#The Traffic Shaping section is where traffic shapes are defined (entries
#defined in this section are referenced from the Interface and PVC
#sections of this file to define which traffic shapes interfaces
#and PVC’s should use).
#
#The Signalling section is where the signalling protocol to be used
#by a physical interface to establish Switched Virtual Circuits
#is specified.
#
#The Interfaces section is where
#such as ARP services and Traffic shapes are bound to specific
#logical interfaces.
#