Installing/removing the server in/from the rack | Hardware installation |
1
1 | 2 |
3 
4
5
4
5
Figure 7: Inserting the server
VCAUTION!
At least two people are needed to position the server in the rack.
ÊFully extend the fitted telescopic rails (1). They must click into place so that they can no longer be moved.
ÊPush the prepared server into the rails that are attached to the rack until the server rails engage (2).
IEnsure that the server is inserted horizontally and is not tilted.
ÊPress the safety springs in on both sides (3).
ÊGently push the server as far as it will go into the rack (4).
ÊFasten the server to the rack (5) using the two knurled screws (front panel). To remove the server, follow this procedure in reverse.
44 | Operating manual | RX330 S1 |
