Controls and displays | Starting up and operation |
Controls
On/Off button
When the system is switched off, it can be switched on again by pressing the On/Off button. When the system is operating, pressing the On/Off button will switch off the system.
IThe On/Off button does not disconnect the server from the mains. To disconnect from the mains completely, remove the power plug(s).
NMI NMI button
IDo not press! The NMI button may only be used by service personnel.
RST Reset button
Pressing the reset button reboots the system.
ID ID button
Lights up (blue) on the front and on the rear of the server when the ID button is pressed. The two ID indicators are synchronized.
Indicators on the control panel
Lights red when the server is switched off but line voltage is present.
Lights yellow during power up delay.
IIf the server is switched off and then immediately switched on again, a server is only restarted after a power up delay. This prevents a current overload, for example.
You can set the power up delay (in seconds) in the BIOS setup in the Server Menu menu with Power Cycle Delay .
Lights up green when the server is switched ON.
Flashes green when the server has been switched on and is in standby mode.
50 | Operating manual | RX330 S1 |
