Fujitsu KA02066D105, T902, FP1000 manual Problem Possible Cause Possible Solutions Video Problems

Problem	Possible Cause	Possible Solutions
Video Problems
The built-in display is	The Tablet PC is set for an	Pressing [F10] while holding down the [Fn] key allows you to change your
blank when you turn on	external monitor only.	selection of where to send your display video. Each time you press the keys
your LIFEBOOK Tablet		you will step to the next choice. The choices, in order are: built-in display only,
PC.		external monitor only, both built-in display and external monitor.
	Display angle and brightness	Move the display and the brightness control until you have adequate visibility.
	settings are not adequate for	Pressing either the [F6] or [F7] keys while holding down the [Fn] key also allows
	your lighting conditions.	you to change the brightness level of the display.
	Power management time-	Press a keyboard button or move the mouse to restore operation. If that fails,
	outs are set for short intervals	push the Power/Suspend/Resume slide. (The display may be shut off by Sleep
	and you didn’t see the display	mode, Auto Suspend or Video Timeout)
	go on and off again.
The Tablet PC turned on	Power On Self Test has	Contact your support representative.
with a series of beeps and	detected a failurethat doesn’t
the built-in display is blank.	allow the display to operate.
The display goes blank by	The Tablet PC has gone into	Press any keyboard button, or move the mouse to restore operation. If that
itself after you have been	Video timeout, Sleep mode,	fails, push the Power/Suspend/Resume slide. Check your power management
using it.	or Save-to-Disk mode	settings, or close your applications and go to the Power Savings menu of the
	because you have not used it	setup utility to adjust the timeout values to better suit your operation needs.
	for a period of time.	See “BIOS Setup Utility” on page 62.
	The power management time-	Press any button on the keyboard, or move the mouse to restore operation. If
	outs may be set for very short	that fails, push the Power/Suspend/Resume slide. (The display may be shut off
	intervals and you failed to	by Sleep Mode, Auto Suspend or Video Timeout)
	notice the display come on
	and go off again.
Your display won’t turn on	The system may be pass-	Check the status indicator panel to verify that the Security icon is blinking. If it is
when the system is turned	word-protected.	blinking, enter your password.
on or when it has
resumed.

97 - Troubleshooting