If you need to change the PSB configuration, use the setupfru(8) command. If the system board to be added is not registered in the DCL, register the system board in the DCL of the target domain by using the setdcl(8) command.

XSCF> showboards -a

 

 

XSB DID(LSB) Assignment

Pwr Conn Conf Test

Fault

----------------------------------------------------------------

00-0

00(00)

Assigned

y

y

y

Passed

Normal

01-0

SP

Available

y

n

n

Passed

Normal

4.Add the new system board.

Execute the addboard(8) command to add the system board to the move- destination domain.

XSCF> addboard -c configure -d 0 01-0

5.Check the status of the domain and added system board.

When the addboard(8) command ends normally, execute the showdcl(8) command to check the operation status of the domain, and then execute the showboards(8) command to check the status of the added system board.

If the addboard(8) command completes abnormally or leaves the board in an unwanted status, refer output messages to identify the problem, then correct it.

XSCF> showdcl -d 0

 

DID

LSB

XSB

Status

 

00

 

 

Running

 

 

00

00-0

 

 

 

01

01-0

 

 

 

 

 

 

XSCF> showboards -d 0

 

XSB

DID(LSB)

Assignment Pwr Conn Conf Test

Fault

------------------------------------------------------------------

00-0

00(00)

Assigned

y

y

y

Passed

Normal

01-0

00(01)

Assigned

y

y

y

Passed

Normal

Chapter 4 Practical Examples of DR 4-7