Furuno FELCOM 12 manual Yy-Mm-Dd, DTE1POR, DTE1IOR, Offegc

7. Press [Enter] to open the selection window.

		Setup
				System Setup
	System Date & Time						(YY-MM-DD)
	Preferred NCS					Auto
	MES Operation		Mode		INMARSATAOR(WEST)-C
	Nav Port				OFFAOR (EAST)
	Active Port				DTE1POR
	Message Output Port				DTE1IOR
	EGC Output Port
9. Configuration

Figure 2-7 System setup menu, preferred NCS

8.Select appropriate NCS (Auto, AOR-West, AOR-East, POR or IOR) by arrow keys. The FELCOM 12 will search for that NCS signal each time it is turned on. The Auto setting searches all NCS signals to find the most suitable NCS; thus, scanning can take quite some time. (For reference, the coverage range of each satel- lite is shown in the figure on page 8.)

If you want to change the NCS channel temporarily, refer to “Se- lecting NCS channel” on page 7-4.

9.Press [Enter] to close the selection window.

10. Press [

/

] to advance the cursor to the MES Operation Mode line.

11. Press [Enter] to open the selection window.

Setup

System Setup

System Date & Time Preferred NCS

MES Operation Mode

Nav Port

Active Port

01:53 97-08-04 (YY-MM-DD)

IOR

INMARSAT-C

OFFEGC

Message Output Port	DTE1
EGC Output Port	DTE1
9. Configuration

Figure 2-8 System setup menu, MES operation mode

12.Select operating mode, either Inmarsat C or EGC. The Inmarsat C setting provides telex communications and operates as an EGC receiver when not transmitting or receiving. The EGC setting en- ables EGC-only receiver operation. In this case EGC RECEIVER appears in reverse indication at the bottom of the screen.

13.Press [Enter] to close the selection window.

14. Press [

/

] to advance the cursor to the Nav Port line.

Note: The MES Operation Mode in the FFA version cannot be set to other than“Inmarsat C.”

2-3