Furuno FELCOM 12 manual IOR INMARSAT-C DTE1 OFF, DTE2 PC/DATA Auto

23. Press [Enter] to open the selection window.

Setup

System Setup

System Date & Time

Preferred NCS

MES Operation Mode

Active Port

Nav Port

Message Output Port

EGC Output Port

9. Configuration

01:53 97-08-04 (YY-MM-DD)

IOR INMARSAT-C DTE1

OFF

DTE1

DTE2

PC/DATA

AUTO

Figure 2-11 System setup menu, message output port

24.Select the DTE where you want to store receive messages.

DTE1: All receive messages are routed to the main DTE (connected to DTE1 on the communication unit) regardless of sub address.

DTE2: All receive messages are routed to the 2nd DTE (connected to DTE2 on the communication unit) regardless of sub address.

PC/DATA: All receive messages are routed to the PC/DATA (connected to PC/DATA on the communication unit) regardless of sub address (not used).

AUTO: Select to route messages with sub address 000 to the main DTE, and messages with the sub address of the 2nd DTE to the 2nd DTE. All other mes- sages are routed to the main DTE.

Note: Do not select DTE2 or Auto when there is no DTE con- nected to the DTE2 port; messages cannot be read from the communications unit.

25.Press [Enter] to close the selection window.

26. Press [

/

] to advance the cursor to the EGC Output Port line.

27. Press [Enter] to open the selection window.

	Setup
		System Setup
System Date & Time			01:53 97-08-04 (YY-MM-DD)
Preferred NCS			IOR
MES Operation Mode			INMARSAT-C
Nav Port			OFF
Active Port			DTE1
Message Output Port			DTE1
EGC Output Port
			DTE1
			DTE1+DTE2

Figure 2-12 System setup menu, EGC output port

28.Select the DTE where you want to store receive EGC messages; DTE1, DTE2 or PC/DATA.

29.Press [Enter] to close the selection window.

2-5