Furuno FELCOM 12 manual Programming NCS Channels, Press Enter to open the text window

6. Press [Enter] to open the text window.

Setup

Configuration

EGC Channel List

ENT: set ESC: quit

11080* 12580* 10840* 11088*

Figure 2-28 EGC channel list, cursor displayed

7.Enter EGC channel frequency code.

8.Press [Enter] to close the text window.

9.Press [Esc] to open the update window.

Setup

Configuration

EGC Channel List

ENT: set ESC: quit

11080*	12580*	10840*		11088*
			Update
				No
			Yes

Figure 2-29 EGC channel list, update window

10.Select “Yes” and press [Enter] to register input.

Note: The EGC channel frequency code range is 8000-14000. Any frequency code entered which is out of this range will display "Input Error: Channel No." Clear the error mes- sage by pressing the [Esc] key. Place the cursor at the in- valid frequency. Then, press the [Enter] key and enter correct frequency.

Programming NCS Channels

This section shows you how to add NCS channels to the NCS Chan- nel List. Up to 19 channels can be listed per each ocean region. Cur- rently, there are four NCS channels, and they are marked with asterisks in the list.

Below is the procedure for adding NCS channels, when they become available.

1.Press [F8] to display the Setup menu.

2.Press [9] to display the Configuration menu.

3.Press [4] to display the NCS Channel List.

2-16