•Press the button (26); the following messages will be dis- played in turn:
SELECT PRODUCT |
| HOT WATER | USE |
READY FOR USE |
| READY FOR |
•Place a cup and/or receptacle beneath the hot water/steam pipe (Fig.15).
•Turn the knob anticlockwise as shown in Fig.15.
•Dispense the desired quantity of hot water; to stop the flow of hot water turn the knob clockwise.
•Press the button (26) again; the machine will switch back to the normal operating mode and the display will show:
SELECT PRODUCT
READY FOR USE
9DISPENSING STEAM / Preparing Cappuccino
Steam can be used to froth the milk for cappuccinos and also to heat beverages.
Scalding hazard! Splashing may occur at the start – scalding hazard! The hot water nozzle and pipe can reach high temperatures: avoid touching it directly with your
hands.
•When the machine is ready to dispense coffee, direct the steam pipe (14) above the drip tray, open the “hot water/steam” knob (16) for a few instants to discharge any residual water from the steam pipe; soon only steam will issue from the nozzle. The display will show:
STEAM
•Turn the knob (16) to OFF.
•Fill 1/3 of the receptacle you wish to use to make cappuccino with cold milk.
For best results when making cappuccinos, the milk and the cup used should be cold.
•Immerse the steam nozzle into the milk to be frothed and turn the knob (16); turn the container slowly with
•After using the steam for the desired time, shut off the steam (16).
•The same method can be used to heat other beverages.
•Clean the steam nozzle with a damp cloth.
Note: Should you wish to use big cups, raise the side 
door and rotate the steam tube; by this way, the steam tube can be further raised (Fig. 17). This is particularly useful
when you use the cappuccinatore.
ENGLISH
10 Optional Accessories
10.1 Cappuccinatore
The cappuccinatore is a device that automatically froths milk, making it extremely easy to prepare classic Ital-
To install the cappuccinatore, proceed as follows:
•Make sure that no other devices are fitted on the steam tube; you must remove any devices that have been installed. I.E. the “Pannarello”.
•Loosen the ring nut without slipping it off the cappuccinatore.
•Insert the cappuccinatore in the steam tube to a depth of about 4 cm.
•Tighten the ring nut securely.
Note: if the ring nut is not securely tightened, the cap- puccinatore may slip out during use.
Hot water with the cappuccinatore
To dispense hot water using the cappuccinatore, follow the direc- tions provided in par.8; hot water will flow out of the lower part of the cappuccinatore.
• 31 •
