5If necessary, set any jumpers on the CD drive assembly. (See your drive documentation for proper drive jumper settings and cable orientation.)
6Place the CD drive assembly in the chassis. Make sure the hooks extend through the slots on the bracket, then slide the CD drive assembly forward.
7Secure the CD drive assembly with the two screws you removed in Step 4.
8Connect the power and data cables, making sure the cables are in the correct position and orientation.
The IDE cable ships with the CD drive kit. Make sure you route the cable directly from the CD drive, through the cable clamp, and to the primary IDE connector on the system board. Other routing may interfere with internal airflow and the thermal characteristics of the server.
9Close the case. See “Closing the case” on page 20.
10Reconnect the power cord and all other external peripheral devices, then turn on the system.
Replacing the CD drive assembly
The CD drive assembly is located beside the diskette drive assembly in the center of the front panel.
Important The replacement drive should include the bracket and small circuit board. If it does not, transfer those components to the new drive.
To replace the CD drive assembly:
1Turn off the system and disconnect the power cord and all other external peripheral devices.
2Open the case. See “Opening the case” on page 18 and “Preventing static electricity discharge” on page 17.
3Remove the power and data cables from the small printed circuit board at the back of the drive. Note their locations and orientations.
Replacing and Adding Internal Devices | 25 |