4Align the drive carrier with the slots at the sides of the drive bay. Leave the retention lever in the open position.

5Push the drive all of the way into the drive bay until the connector at the back joins with the corresponding connector on the SCSI backplane, then firmly close the lever.

6Run any necessary utilities to setup the new drive. See the utility software documentation for details.

Memory

Four DIMM sockets on the system board support up to 4.0 Gigabytes (GB) of PC/133 SDRAM.

The DRAM DIMMs supported by the system board conform to the following standards:

■128 MB, 256 MB, 512 MB, and 1024 MB ECC DIMMs

■PC/133-compliant, registered, ECC SDRAM

■128 MB minimum system memory

■4.0 GB maximum system memory

When you select and install DIMMs, keep the following in mind:

■Do not use unbuffered DIMMs.

■Memory should be added in order, from DIMM 1 to DIMM 4.

■There can be no empty slots between installed DIMMs.

■No jumper settings are required for the memory size or type because the BIOS automatically detects this information.

Important Gateway recommends that you purchase memory upgrades through Gateway sales. An incorrect memory match may adversely affect the performance of the server.

Replacing and Adding Internal Devices

31