Processors

The system is compatible with the Intel® Pentium® III 866 MHz and faster processors with 133 MHz front-side bus (FSB). As many as two processors may be installed in the system. You do not need to install additional voltage regulator modules (VRMs), because the VRMs for both processors are built into the system board.

The server uses different heat sinks for the primary and secondary processors. When ordering a replacement or upgrade processor, make sure that you order the correct processor kit for the processor you are installing. The primary processor, located closer to the front of the server, uses a smaller heatsink. The secondary processor, located closer to the back of the server, uses a larger heatsink.

Replacing the primary processor

When replacing a processor, order a processor upgrade from The Accessory Store on the Gateway Web site.

Caution A heatsink must be installed on each processor. Installing a processor without a heatsink could result in damage to, or failure of, the processor.

To replace the primary processor:

1Turn off the system and disconnect the power cord and all other external peripheral devices.

2Open the case. See “Opening the case” on page 18 and “Preventing static electricity discharge” on page 17.

3Locate the primary processor, see “System board” on page 6 for the location of the system board components.

34Gateway 7450R Server System Manual