Expansion cards

The server has two expansion slots on the riser card that can be used for a variety of expansion cards. These slots support 64-bit, 66 MHz PCI cards. Both slots will hold full-length, full-height cards.

Replacing an expansion card

You must install an expansion card in slot 1 before you can install an expansion card in slot 2.

To replace an expansion card:

1Set any jumpers and switches on the replacement card, if required in the card instructions.

2Turn off the server, then disconnect the power cord and all external peripheral devices.

3Open the case. See “Opening the case” on page 18 and “Preventing static electricity discharge” on page 17.

4Disconnect any cables attached to the old card.

5Remove the screw that holds the expansion card bracket in place.

Expansion card bracket

Screw

Expansion card

Replacing and Adding Internal Devices

43