GENICOM LN45 and Intelliprint mL450 Installation Guide
Regulatory Compliances
"If debris (metal or liquid) migrates into the machine, switch off and unplug the machine. Contact your point of purchase. Operating a
"Never open or remove machine covers that are secured with screws unless specifically instructed in the "User's Manual."
"A high voltage component can cause a shock hazard.
"Do not try to alter the machine configuration, or modify any parts. An unauthorized modification can cause smoke or fire.
"Never throw a drum cartridge into an open flame. Toner remaining in the cartridge can cause an explosion and you can get burnt.
"Do not place a magnet near the safety switch of the machine. A magnet can activate the machine acci- dentally, resulting in injuries.
"Do not place any heavy object on the machine. An
"Do not use a highly flammable spray near the machine. It can cause a fire.
"Stop operation immediately if your machine produces smoke, excessive heat, unusual noise, or smell, or if water is spilled into the machine. These conditions can result in a fire. Immediately switch off and unplug the machine, and contact your point of purchase.
"To prevent a fire or shock hazard, follow the instruction below based on your machine configuration. If in doubt, contact your point of purchase.
CAUTION: Do not place the machine near heaters or volatile, flammable, or combustible materials such as curtains that may catch fire.
Paper Jam Precautions
"The fuser becomes very hot in operation. If a paper jam has occurred, turn the power off and wait at least 40 minutes before removing the drum cartridge and touching the fuser section.
"When clearing a jammed paper that is difficult or impossible to see, do not try to remove it by yourself. Doing so can cause injuries. Contact your point of purchase.
"When removing jammed paper, make sure that no pieces of torn paper are left in the machine. A piece of paper remaining in the machine can cause a fire.
"If a sheet of paper is not able to be removed or wrapped around the heat roller, do not try to remove it by yourself. Doing so can cause injuries. Switch off the machine immediately, and contact your point of purchase.
Regulatory Compliances
Class B Equipment
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interfer- ence in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio com- munications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Publication No. | Genicom | Aug 01 |
