Genicom ML450, LN45 manual Cover Open Close Door G

6-26

GENICOM LN45 and Intelliprint mL450 User Guide

Control Panel LCD Messages

Code Class 7

LCD MESSAGE	LCD MESSAGE	CAUSE OF	REQUIRED
(LINE 1)	(LINE 2)	ERROR MESSAGE	ACTION
7-1 COVER OPEN	CLOSE DOOR G	Finisher front cover is	Close Finisher front
		open	cover – Door G
7-2 COVER OPEN	FIN. TOP DOOR	Finisher top cover	Close Finisher top
		open	door
7-3 DUPLEX OPEN	CLOSE DUPLEXER	Duplexer cover open	Close duplexer cover
7-3 FIN EXIT SW	CHECK FIN EXIT	Finisher Exit Roller Unit	Close Finisher Exit
		is open	Roller Unit
7-3 HCF ERROR	CALL SERVICE	Cannot Read/Write	Service Call required
		HCF NVM
7-4 HCF ERROR	CALL SERVICE	HCF NVM failure	Service Call required
7-7 HCF ERROR	CALL SERVICE	Communications error	Check HCF Cabling -
		between MCU and HCF	Service Call required
		(see note 2)
7-71 FINISH JAM	CLEAR TOP TRAY	Paper did not pass the	Clear paper jam
		top tray exit path	finisher top tray
		sensor
7-72 FINISH JAM	CLEAR TOP TRAY	Paper did not reach	Clear paper jam
		top tray exit path	finisher top tray
		sensor
7-73 FINISH JAM	CLEAR TOP TRAY	Top tray exit path	Clear paper jam
		sensor on while	finisher top tray
		finisher is being
		initialized
7-76 FINISH JAM	CLEAR TOP TRAY	Remaining paper is	Clear paper jam
		detected by top tray	finisher top tray
		exit path sensor

Publication No. GEG-99126 Genicom Aug 01