GENICOM LN45 and Intelliprint mL450 Installation Guide
Class 1 Laser Device and CDRH Compliance
"Reorient or relocate the receiving antenna.
"Increase the separation between the equipment and receiver.
"Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
"Consult with the dealer or an experienced radio/television technician for help.
"Always use the power cord provided with your machine. When an extension power cord is required, always use a properly rated cord.
"In Japan: 125V/15A
"In other countries: Contact your point of purchase.
If your machine is a
Class 1 Laser Device and CDRH Compliance
This equipment is certified as a Class 1 laser product. This means that the machine does not emit hazardous laser radiation.
Do not try anything which is not instructed in this User’s guide. An unauthorized operation can cause injuries or damage to the machine.
This equipment is in the 2nd class category (information equipment to be used in a residential area or an adjacent area thereto) and conforms to the standards set by the Voluntary Control Council For Interference by Information Technology Equipment aimed at preventing radio interference in such residential area.* When used near a radio or TV receiver, it may become the cause of radio interference. Read the instructions for correct handling.
* This regulation applies only to Japan.
This printer is certified as a Class 1 laser product under the U.S. Department of Health and Human Services (DHHS) Radiation Performance Standard according to the Radiation Control for Health and Safety Act of 1968. This means that the printer does not emit hazardous laser radiation.
Since radiation emitted inside the printer is completely confined within the protective housings and external covers, the laser beam cannot escape from the machine during any phase of user operation.
The Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration imple- mented regulations for laser products on August 1976. These regulations apply to laser products marketed in the United States. The label on the printer indicates compliance with the CDRH regulations and must be attached to laser products marketed in the United States.
Radio and Television Interference
When installed at a certain location, the machine may cause interference with radio and television reception. If you notice flickering or distorted images or noises on your
Switch it off, and if the interference disappears, the machine is the cause of radio interference. Perform the following procedure until the interference is corrected.
"Move the machine and the TV and/or radio away from each other.
"Reposition or reorientate the machine and TV and/or radio.
"Unplug the machine, TV and/or radio, and replug them into outlets that operate on different circuits.
Aug 01 | Genicom | Publication No. |
