Genicom LN45, ML450 manual System Menu, Display Language, Alarm Control, Power Saver, Wait Timeout

GENICOM LN45 and Intelliprint mL450 User Guide

Pushbuttons

4-17

System Menu

The system menu provides access to system settings. Use the following procedure to enter the system menu:

1.Press the MENU button on the control panel.

2.Press the NEXT button until the text “System Menu” is shown on the second line of the display.

3.Press the SELECT button to enter the system menu.

4.Press the NEXT button to move through the submenus: Factory Defaults, Display Language,

Power Saver, Wait Timeout, Job Timeout, Jam Recovery, Hex Print, and Toner Out.

5.Press the SELECT button to enter a submenu.

6.Use the procedures in the following table to access and change the system settings:

Submenus	Default Setting	Available Settings	Procedure for Changing Setting
Factory Defaults	U.S.	U.S.	1.	Press NEXT or PREVIOUS to toggle
This submenu allows you to reset		Non-U.S.		between U.S. and NON-U.S.
the printer to U.S. or Non-U.S.			2. Press SELECT to choose and set the
factory defaults.				factory defaults.
Display Language	English	English	1.	Press NEXT or PREVIOUS to scroll
This submenu allows you to change		Francais (French)		through the available languages:
the language of the display		Deutsch (German)		English, French (Francais), German
messages.		Italiano (Italian)		(Deutsch), Italian (Italiano), or
		Espanol (Spanish)		Spanish (Espanol).
			2. Press SELECT to choose and set the
				language.
Alarm Control	Single	Single	1.	Press NEXT or PREVIOUS to move
This submenu allows you to set the		Continuous		among the alarm settings.
alarm control.		Off	2. Press SELECT to choose and set the
				alarm setting.
Power Saver	15	0 - 999	1.	Press NEXT or PREVIOUS to
This submenu allows you to set the				increase or decrease the number of
number of minutes the printer is				minutes.
idle before it reverts to Power			2.	Press SELECT to save this setting.
Saver Mode.
Wait Timeout	20	0 - 99999	1.	Press NEXT or PREVIOUS to
This submenu allows you to				increase or decrease each digit of
increase or decrease the length of				the five-digit number.
time (in seconds) that the printer			2.	Press SELECT set one digit and
will remain in the waiting state—a				move to the next digit.
job is being processed, no			3.	Press SELECT after changing the
end-of-file has been detected, and				last digit to save this setting.
there is no more data to process.
This setting applies to both PCL
and PostScript print jobs.

Aug 01 Genicom Publication No. GEG-99126