Heat Controller MSH-024B/A 2sanoev, Terminals and fasten the wire tightly with the fixing screw

Connection method of the connecting -cable(Example)

(1)Dismount two-caps on the conduit panel.

(2)Make a hole appropriate for the passage of connection cable through on cap by tool. (for low voltage line)

(3)Pass the connecting cable through the hole.

(4)Property connect the cable on the terminal block

(5)Fix the connection cable with clamp cord provided on the unit not to have strain at the terminal when the connection cable Is pulled outside up to a 35 pound weight.

(6)Wind the vinyl tape round the connecting cable for sealing between the surface of the connection cable and cap.

(7)Mount the taped part of cable on the cap.

(8)Finally, mount the holed cap with the wound cable on the conduit panel.

INEM3

Loose wiring may cause the terminal to overheat or result in unit malfunction. A fire hazard may also exist. Therefore, be sure all wiring is tightly connected.

When connecting each power wire to the corresponding

terminal, follow instructions "How to connect wiring to the

terminals' and fasten the wire tightly with the fixing screw of

the terminal plate.

For strand wiring

(1)Cut the wire end with a wire cutter or wire-culling pliers, then strip the insulation to expose the strand wiring about 10mm(318').

(2)Using a screwdriver, remove the terminal screw(s) on the terminal plate.

(3)Using a round terminal fastener or pliers, securely clamp each stripped wire end with a round terminal.

(4)Position the round terminal wire, and replace and tighten the terminal screw using a screwdriver.

"

		block
Clamp cord	00
Cap(Reuse)	j	Lock nut
Hole		Cap
(VINN)
		(Remove)
Taping
(for sealing)		Powersupply line
		(t e,2sanoev)
Low voltage line	panel
(connecting cable)

"

Strand wire

ýýb O Round terminal

n

1

Screwwith especial washer

Samwkh

*Roundterminalspecialwasher malplate

Wire

Wire

-34-

"