Heat Controller MSH-01 2B/A, MSH-0186/A, MSS-018B/A, MSS-009B/A manual Bwid, Forming the pipings

"

3) Forming the pipings

1.Wrap the connecting portion of indoor unit with the Insulation material and secure It with two Plastic Bands.(for the right pipings)

"n you want to connect an additional drain hose, the end of the drain-outlet should keep distance from the

ground.(do not dip it into water, and fix it on the wag to avoid swinging In the wind.)

Incase of the Outdoor tmit.beirtg installed below position oftheIndoor urtff =_

2.Tape the Pipings, drain hose and Connecting Cable from down to up.

3.Form the pipings gathered by taping along the exterior wall and fix it onto the wall by saddle or equivalent.

Seal a small opening around the pipings with

gum type sealer.

Main hose '

Taping

I

edM

plastic jL-rýd6lme

bwid

Trap is required to prevent water from entering into electrical parts.

"

In case of the Outdoor unit being installed above - position of the Indoor unit

2.Tape the Pipings and Connecting cable from down to up.

3.Form the pipings gathered by taping along the exterior wall, make the Trap to be required to prevent water from entering into the room.

4.Fix the pipings onto the wall by saddle or equivalent.

-37-

Seal a small opening around the pipings

with gum type sealer.

4