Manuals / Henny Penny / Kitchen Appliance / Fryer

Henny Penny EEG-143 Do Not Store Or Use Gasoline Or Other Flammable Vapors, FM05-057-C Revised

Models: EEG-143 EEG-144 EEG-141 EEG-142

1 72

Download 72 pages 1.4 Kb

Page 3

DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS

Model EEG-141, 142, 143, 144

This manual should be retained in a convenient location for future reference.

Awiring diagram for this appliance is located on the inside of the door.

Post in a prominent location, instructions to be followed in event user smells gas. This information shall be obtained by consulting the local gas supplier.

Do not obstruct the flow of combustion and ventilation air.Adequate clearance must be left all around appliance for sufficient air to the combustion chamber.

The Model EEG-10X open fryer is equipped with a continuous pilot. But the open fryer cannot be operated without electric power, and no attempt should be made to operate the fryer during a power outage. The unit will automatically return to normal operation when power is restored.

To avoid a fire, keep appliance area free and clear from combustibles.

Improper installation, adjustment, alteration, service, or maintenance can cause property damage, injury, or death. Read the installation, operating, and maintenance instructions thoroughly before installing or servicing this equipment.

DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS

AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. FIRE OR EXPLOSION COULD RESULT.

FM05-057-C

Revised 5-28-10

Image 3

Henny Penny EEG-143, EEG-142, EEG-141, EEG-144 Do Not Store Or Use Gasoline Or Other Flammable Vapors, FM05-057-C Revised

Contents

Model EEG-141 Model EEG-142 Model EEG-143 Model EEG-144 OPERATOR’S MANUALHenny Penny Evolution Elite Reduced Oil Capacity Open Fryers Split Vat & Full Vat- GasPage FM05-057-C Revised DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORSTechnical Data for CE Marked Products Revised 01/01/07 LIMITED WARRANTY FOR HENNY PENNY EQUIPMENTTABLE OF CONTENTS SectionPage Fryer Setup TABLE OF CONTENTS ContinuedSection PagePage 1-3. PROPER CARE 1-2. FEATURESSECTION 1. INTRODUCTION 1-1. INTRODUCTIONAVOIDED, WILL RESULT IN DEATH OR SERIOUS INJURY SAFETYASSISTANCE DANGER INDICATES AN IMMINENTLY HAZARDOUS SITUATION WHICH, IF NOTShock Hazard Symbols OR Hot Surface Symbols OR 1-5. SAFETY ContinuedEquipotential Ground Symbol Waste Electrical and Electronic Equipment WEEE SymbolPage SECTION 2. INSTALLATION 2-1. INTRODUCTION2-2. UNPACKING To prevent severe burns from splashing hot oil 2-3. SELECTING THE FRYER LOCATION 2-4. LEVELING THE FRYER2-6. GAS SUPPLY 2-6. GAS SUPPLY Continued Model EEG-141, 142, 143 2-6. GAS SUPPLY Continued2-9. ELECTRICAL REQUIREMENTS 2-7. GAS LEAK TEST 2-8. GAS PRESSURE REGULATOR SETTING2-11. LIGHTINGAND SHUTDOWN OF THE BURNERS 2-9. ELECTRICAL REQUIREMENTS Continued 2-10. MOTOR BEARINGSModel EEG-141, 142, 143 2-12. DIMENSIONSPage Bulk Oil Supply Fryers Only SECTION 3. OPERATION3-1. OPERATING COMPONENTS Refer to explanations on the next pages3-1 3-1 3-1 3-1 3-1 3-1 3-1 3-1. OPERATING COMPONENTS ContinuedDescription FunctionFunction Continued3-1. OPERATING COMPONENTS DescriptionVat Covers DescriptionFunction Drain Valve Knob3-2. SET-UP MODE 3-3. FILLING OR ADDING OIL 3-4. MORNING START-UP PROCEDURES 3-5. BASIC OPERATION 3-6. IDLE MODE 3-7. OIL GUARDIAN Auto Top-Off 3-8. SELECTINGA PRODUCT WITHADIFFERENT SETPOINT 3-9. REPLACING THE JIBManual Top-Off Removing/Cleaning Reservoir 3-10. MODEL EEG-141 OIL RESERVOIRFilling Oil Reservoir 3-11. SMARTFILTER EXPRESS 3-11. SMARTFILTER EXPRESS Continued Filter Error3-12. DAILY FILTERING 3-12. DAILY FILTERING Continued 3-13. DISCARDING OIL FROM VAT USING OPTIONAL OIL DISCARD SHUTTLE 3-14. DISCARDING OIL FROM VAT USING OPTIONAL BULK OIL DISPOSE SYSTEM 3-15. CHANGING THE FILTER PAD 3-15. CHANGING THE FILTER PAD Continued 3-16. REMOVING AND CLEANING BASKET REST 3-15. CHANGING THE FILTER PAD ContinuedBe sure that the drain pan, bottom screen, crumb catcher, and the retaining ring are thoroughly dry before placing filter pad into pan as water will dissolve the filter pad 3-17. CLEAN-OUT MODE 3-17. CLEAN-OUT MODE Continued “RINSE COMPLETE” “YES NO” 3-17. CLEAN-OUT MODE ContinuedTo prevent oil leaking, and to keep filtering process operating properly, the filter drain pan o-rings should be inspected for nicks and tears at least every 3 months. Figure 3-18. CHECK/REPLACE FILTER DRAIN PAN O-RINGSRecovery Information for each Vat Actual Oil Temperatureand the actual oil temperature shows in the Set-point TemperatureProcedureFrequency 3-21. PREVENTIVE MAINTENANCE SCHEDULE3-22. CLEAN BLOWER & VENTS Page 4-1. INFORMATION MODE DETAILS SECTION 4. INFORMATION MODE4-1. INFORMATION MODE DETAILS Continued FUNCTIONDISPLAY EX to view data for other days of week 4-1. INFORMATION MODE DETAILS ContinuedPress button to start viewing the cook data Press the right4-1. INFORMATION MODE DETAILS Continued FUNCTIONDISPLAY EX DISPLAY EX Reset usage data4-1. INFORMATION MODE DETAILS Continued FUNCTIONAssign Button 5-1. MODIFYING PRODUCT SETTINGSSECTION 5. PRODUCT PROGRAM MODE Change Product NamesQuality Timer hold time 5-1. MODIFYING PRODUCT SETTINGS ContinuedTo Change Times and Temperatures Alarms 1MixFilterdAfterFil TrackingX Number of Loads 5-1. MODIFYING PRODUCT SETTINGS ContinuedLoad Compensation, Load Compensation Reference, Full Heat, PC Factor Stats SECTION 6. LEVEL 2 PROGRAMMING6-1. SPECIAL PROGRAM MODE Tech ModeLanguage SP-2 Audio Volume SP-46-1. SPECIAL PROGRAM MODE Continued Degrees Fahrenheit or Celsius SP-16-1. SPECIAL PROGRAM MODE Continued Idle Mode Enabled SP-7Audio Tone SP-5 Liquid or Solid Cooking Oil Used SP-6Cycle Filter Tracking Mode SP-8MIXED 6-1. SPECIAL PROGRAM MODE ContinuedFilter Tracking Mode SP-8 Continued GLOBAL 6-1. SPECIAL PROGRAM MODE ContinuedIf GLOBAL is selected, press button Polish Duration SP-9 Clean-Out Time SP-11Clean-Out Temperature SP-12 Cooking Indicator SP-15Fryer Type SP-19 2nd Volume SP-172nd Language SP-16 Engery Save Mode SP-18Serial Number Log SP-24 Autolift Enabled SP-21Bulk Oil Supply SP-22 Bulk Oil Disposal SP-23Longer Fill Time SP-28 Program Code Change SP-25 ContinuedUsage Code Change SP-26 Dispose Requires Code ? SP-276-3. DATA LOGGING, HEAT CONTROL, TECH, STAT, AND FILTER CONTROL MODES 6-2. CLOCK SETCorrection SECTION 7. TROUBLESHOOTING 7-1. TROUBLE SHOOTING GUIDEProblem CauseCause 7-1. TROUBLE SHOOTING GUIDEProblem ContinuedCORRECTION 7-2. ERROR CODESDISPLAY CAUSECORRECTION 7-2. ERROR CODESDISPLAY CAUSEPage Toll free in USA Henny Penny Corporation P.O.Box Eaton,OH