Henny Penny EEG-142, EEG-141, EEG-144, EEG-143 warranty Remove the right side panel

			Model EEG-141, 142, 143, 144
7-1. TROUBLE SHOOTING GUIDE
(Continued)
Problem	Cause		Correction
Oil foaming or boiling	• Water in oil	•	Drain and clean oil
over top of vat	• Improper or bad oil	• Use recommended oil
	• Improper filtering	•	Refer to filtering procedures
	• Improper rinsing after	• Clean and rinse vat and then
	cleaning the vat		dry thoroughly
Oil will not	• Drain valve clogged	• Open valve, force cleaning brush
drain from vat	with crumbs		through drain
	• Drain trough clogged	• Remove right side panel and remove
			plug from end of trough and clean
			trough
Filter motor runs but	• Filter line connections loose	• Tighten all filter line connections
pumps oil slowly	• Filter paper or pad
	clogged	• Change filter paper or pad
	• Filter not reassembled	•	Refer to assembly instructions on inside
	correctly		of door
Bubbles in oil during	• Filter pan not completely	•	Make sure filter pan return line is
entire filtering process	engaged		pushed completely into the receiver on
	• Filter pan clogged		the fryer
		• Clean pan and change paper or pad
	• Damaged O-ring on filter	• Change O-ring
	line receiver on fryer
Filter motor will not run	• the thermal reset button on	• Remove the right side panel and
	the rear of the pump motor		allow time for the motor to cool
	is tripped		and then, using a screwdriver,
			press hard against the button
			until it clicks

To prevent burns caused by splashing shortening, turn the unit's POWER switch to the OFF position before resetting the filter pump motor’s manual reset protection device.

7-2 609