Henny Penny EEG-144, EEG-142, EEG-141, EEG-143 warranty Error Codes Display Cause Correction, Closed

Model EEG-141, 142, 143, 144

7-2. ERROR CODES

DISPLAY	CAUSE	CORRECTION
“E-20-A”	• Pressure Switch	• If fan is not running, have pressure switch checked; should be
“FAN SENSOR	failure	open circuit if no air pressure
STUCK	• wiring problem	• If fan is running, wiring error, or relay on I/O board closed
CLOSED”	• I/O board failure
“E-20-B”	• Pressure Switch	• Press power button to vat off and back on again, if E-20-B
“NO DRAFT”	failure/hose loose	persists, have pressure switch checked; should be open circuit
“CHECK	• Draft Fan failure/	if no air pressure; make sure hose is connected to fan and
FAN”	low voltage	pressure switch
	• Flue or hood	• Have draft fan checked; low voltage going to fan
	obstructions	• check the fryer flue and hood system for obstructions
“E-20-D”	• Failure to ignite/	• Press power button to vat off and back on again, if E-20-D
“IGNITION”	no flame sense	persists, check gas line connections; check gas shut-off valve;
“FAILURE”		have ignition module checked; gas valve checked; flame sensor
		gap checked; gas valve and ignition module wiring checked
“E-21”	• Slow heat recovery	• Have a certified service technician check the fryer for correct
		voltage to the unit; have heat circuit checked; have unit
		checked for loose or burnt wire
“E-22”‘NO	• Burner not igniting	• Have gas valve and heat circuit checked
HEAT” “CHECK
GAS VALVE”
“E-41”, “E-46”	• Programming	• Press power button to vat off and back on again, if any
	failure	of the error codes, have the controls re-initialized; if error code
		persists, have the control board replaced
“E-47”	•Analog converter	• Press power button to vat off and back on again, if “E-47”
	chip or 12 volt	persists, have the I/O board, or the PC board replaced; if
	supply failure	speaker tones are quiet, probably I/O board failure; have the
		I/O boardreplaced
“E-48”	• Input system error	• Have PC board replaced
“E-54C”	• Temperature input	• Turn switch to OFF, then back to ON; have control PC board
	error	replaced if “E-54C” persists
“E-60”	• AIF PC board not	• Press power button to vat off and back on again if “E-60”
	communicating with	persists, have the connector between the PC boards checked;
	control PC board	replace AIF PC board or control PC board if necessary
7-4		809