Honeywell HRDE4X4 manual DVR Configuration, Front Panel LEDs and Controls

3

DVR Configuration

This chapter covers:

•Front panel LEDs and controls

•Initial DVR setup

•Configuring live and recording modes

•Setting motion zones

•Setting recording schedules

•Setting system parameters

•Configuring remote network control

•Setting storage parameters

Note Ensure that your DVR is completely installed and all components are connected before proceeding.

Front Panel LEDs and Controls

Figure 3-1shows the front panel and Table 3-1and Table 3-2describe the operational LEDs and control buttons.

Figure 3-1 Front Panel

Table 3-1 Front Panel LEDs

LED Function

POWER ON indicates power is applied to the unit.

REC	ON indicates recording is enabled.
HDD	ON indicates the system is accessing the hard drive.
EVENT	ON indicates the alarm sensor(s) has/have been triggered or motion is
	detected.
NETWORK	ON indicates a user is connected to the system through the RAS software.
Rev 2.00	11	Document 900.0399
		03/06