Honeywell HRDE4X4 manual Typical DVR Installation, Setting Unit for Ntsc or PAL

Typical DVR Installation

Four Video Inputs for Cameras

Four Audio

Inputs

RS-232 for

Engineering Use

LAN for Remote Access Software Connection

1 Internal Alarm

Output Relay

Four Sensor	Audio Line
Inputs
	Output
	CCTV Monitor

To 12 VDC

Adapter

VGA Monitor

Setting Unit for NTSC or PAL

Before turning on your DVR, set the switch (see Figure 2-1) to NTSC or PAL to match your equipment. If your DVR is already powered, unplug the power cord from the wall outlet. Wait a few seconds, set the switch (see Figure 2-1), and then re-apply power.

Note You cannot mix NTSC and PAL equipment. For example, do not connect NTSC cameras when your DVR is set to PAL. Similarly, do not connect a PAL camera and an NTSC monitor.

Rev 2.00	6	Document 900.0399
		03/06