![](/images/new-backgrounds/1204921/20492157x1.webp)
Controlling a PTZ Camera
To control the PTZ functions of the camera, connect the controller to the RS485 port on the rear panel (see Figure
Note For speed dome cameras that support RS485, connect them directly to the RS485 port.
If the camera is controlled with RS232C, use an RS485 to RS232C signal converter.
On the PTZ Control Setup screen (see Figure
•CAMERA SPEED (19200, 14400, 9600, 4800, 2400)
•CAMERA NUMBER (channel number that the PTZ is connected to)
•CAMERA TYPE (protocol type)
•CAMERA ID
Figure 3-11 PTZ Control Setup Screen
Setting Network Parameters
Set up your network parameters (for remote connection through the Remote Access Software) on the Network Setup screen. See Chapter 5, Chapter 6, and Chapter 7 for more information about RAS.
Rev 2.00 | 21 | Document 900.0399 |
|
| 03/06 |