Honeywell LYNXR Series Record Custom Voice Descriptors, 40, Assign custom voice descriptors

✻85 Record Custom Voice Descriptors

Use this mode to record up to 5 custom voice descriptors. Press ✻85 while in Programming mode.

Note: Entering a number other than one specified will give unpredictable results.

		Assign custom voice descriptors	Entering “1” advances to the next prompt below.
	85	0 = exit mode	Entering “0” exits mode, upon which this prompt blinks, indicating the
			mode is inactive.
		1 = enter mode
		Custom descriptor number	Record up to 5 custom words.
A	7d
		Enter 7 + d + [✻]
		Where d = 0-4, each representing custom
		word 70, 71, 72, 73, or 74, respectively. Any
		existing word will be announced.
		Press [#] to start recorder. Begin speaking
		immediately after the third beep.
		Speak the desired word clearly near the
		microphone. Recording stops after 1.5
		seconds.
		6 = accept word and ready to record next
		descriptor prompt (A….7d)
		[#] = re-record descriptor
		00 = exit Record mode after pressing 6 to
		accept word
		Press any key to repeat the recorded word.

–40–