Honeywell Remote Phone Control Feature, Speaker Phone Operation LYNXR-ENOnly, System Operation

System Operation

Speaker Phone Operation (LYNXR-EN Only)

To place a call or answer a call using the speaker phone: [#] +

To flash (switch between two calls using call waiting): AUX

To hang up and exit speaker phone mode: OFF

To enable/disable (toggle) ringer: [#] + VOLUME + AUX

AUX

NOTE

The ARMED and READY LEDs blink alternately when the Speaker Phone is active.

To return the keypad to telephone mode after disarming the system: [#] +

AUX

Remote Phone Control Feature

The remote phone control feature, which must be enabled in field ✻91, allows the user to access the security system from any off-site touch-tone telephone. The control will pick up the incoming call, based on the ring count specified in field ✻95, and will announce “SYTEM” every three (3) seconds for the next eight (8) seconds. During this period the panel will wait for a valid User Code to be entered. If a valid User Code is not entered or the eight (8) second period expires a modem tone will be generated for remote programming (Compass Downloading). If a valid User Code has been entered, the control will announce the current system status and/or beeping sounds.

Keypad Functions

Remote Phone Control Feature
To remotely disarm system:	+ [1]
To remotely arm in AWAY mode:	+ [2]
To remotely arm in STAY mode:	+ [3]
To remotely arm in AWAY or STAY with no delay:		+ [2] or [3] + [0]
To remotely activate X-10 devices 1-6:[#] + [4] + device no.
To remotely activate X-10 devices 7 & 8:		+ [#] + [4] + device no.
To remotely deactivate X-10 devices 1-6:[#] + [7] + device no.
To remotely deactivate X-10 devices 7 & 8:		+ [#] + [7] + device no.
To remotely Bypass zones:	+ [6] + zone no.
To remotely activate Forced Bypass:	+ [6] + [#]
To remotely check system status: [✻]
To end remote phone control session: Hang Up or		+ [9]

Quick Arm Note

The installer code and babysitter code cannot disarm the system if armed by Quick Arm method.

–49–