Viewing reports

You can view some reports from the Embedded Web Server. These reports are useful for assessing the status of the printer, the network, and supplies.

To view reports from a network printer:

1Type the printer IP address into the address field of your Web browser.

Note: If you do not know the IP address of the printer, then print a network setup page and locate the IP address in the TCP/IP section.

2Click Reports, and then click the type of report you want to view.

Adjusting Power Saver

Available settings range from 1–240 minutes. The factory default is 30 minutes.

To increase or decrease the number of minutes before the printer enters Power Saver mode, do one of the following:

Using the Embedded Web Server

1Type the printer IP address into the address field of your Web browser.

Note: If you do not know the IP address of the printer, then print a network setup page and locate the IP address in the TCP/IP section.

2Click Settings, and then click General Settings.

3Click Timeouts.

4In the Power Saver box, increase or decrease the number of minutes you want the printer to wait before it enters Power Saver mode.

5Click Submit.

Using the printer control panel

1Make sure the printer is on and Ready appears.

2Press .

3Press the arrow buttons until Settings appears, and then press .

4Press the arrow buttons until General Settings appears, and then press .

5Press the arrow buttons until Timeouts appears, and then press .

6Press the arrow buttons until Power Saver appears, and then press .

7Press the arrow buttons to increase or decrease the number of minutes before the printer enters Power Saver mode, and then press .

Administrative support

168