Connect using wireless

The HP Officejet 7400 series all-in-one uses an internal networking component that supports a wireless network. Detailed instructions on connecting your HP all-in-one to a wireless (802.11b or g) network are included in the Setup and Network Guides that came with your device.

Connect using the HP bt300Bluetooth Wireless Printer Adapter

The HP bt300 allows you to print images from most Bluetooth devices directly to your HP all-in-one without a cable connection. Simply insert the HP bt300 into the PictBridge camera port located on the front of the HP all-in-one and print from a Bluetooth device such as a PDA or camera phone.

Note Using Bluetooth technology to print from a PC or laptop to your HP all-in-one is not supported at this time.

To connect the HP bt300 to your HP all-in-one

1 Insert the HP bt300 into the PictBridge camera port (shown in the graphic below).

Note If you insert the HP bt300 into your HP all-in-one and a message displays on your color graphics display that says No Bluetooth, disconnect the adapter from the HP all-in-one and refer to Device update.

2Some Bluetooth devices exchange device addresses when they communicate with each other and establish a connection. If your Bluetooth device requires the address of your HP all-in-one to make a connection:

a Press Setup on the control panel of your HP all-in-one.

The Setup Menu appears on the color graphics display.

bPress 0, then press 1.

This displays the Bluetooth menu and then selects Device Address. The Device Address for your HP all-in-one displays. It is read only.

cTo enter the address into your device, follow the instructions that came with your Bluetooth device.

information Connection

User Guide

19