NOTE: To make the Print on Both Sides (Manually) check box available in the document options, select the Allow Manual Duplexing option on the Device Settings tab in the print-driver Properties tab set. See Installable Options on page 162.

If you want to print on both sides manually while using paper that is supported for automatic duplexing, you must select and apply the Not Installed setting on the Allow manual duplexing option on the Device Settings tab.

Cardstock paper can be manually printed on the second side, but no change occurs to the print mode. Transparencies and labels should never be manually printed on the second side.

To print a multiple-page document, follow these steps:

1.Select the Print on Both Sides (Manually) check box.

2.Click OK. The even-number pages of the document print.

3.When the control panel shows the MANUALLY FEED message, insert the stack of paper (on which the even-number pages have been printed) as indicated in the following figure.

Figure 4-15Print on Both Sides Instructions dialog box

When you have completed the steps that appear in the dialog box, the second half of the print job prints on the back side of the stack of paper. The driver does not require the program to specifically support odd- and even-page printing, because the driver coordinates this function.

Flip Pages Up

Use the Flip Pages Up check box to specify the duplex-binding option. By default, the Flip Pages Up check box is not available. It is available only when Print on Both Sides is selected. The following table demonstrates the results of selecting this check box, depending on the paper orientation selected on the Finishing tab.

ENWW

Finishing tab features 137