kug-appc Page 13 Thursday, March 6, 1997 4:51 PM

P o s t S c r i p t S I M M

Removing thePostScript SIMM

SIMMs and controller boards are sensitive to static electricity. Before removing a SIMM, discharge static electricity from

your body by touching something metal, such as the metal

Caution back plate on any device plugged into a grounded power source. If you walk around before finishing the removal,

again discharge any static electricity.

Never remove the printer controller board while the printer is plugged in.

1 Power OFF the printer and disconnect the power cord and any interface cables.

2 Loosen the thumb screws and pull out the

3 Place the controller board on a ream of

controller board.

paper.

A p p e n d i x C : I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s ❖ C-13