kug-appc Page 11 Thursday, March 6, 1997 4:51 PM

P o s t S c r i p t S I M M

4 Select an appropriate SIMM slot to use.

Slots SIM0 (A) and SIM1 (B) are interchangeable and are used for installing the PostScript SIMM.

6 Make sure that the clips on either side snap closed to lock the PostScript SIMM in place.

5 Insert the PostScript SIMM vertically into the appropriate SIMM slot and rotate it down into position.

7 Replace the controller board, sliding it along the alignment channels. Then hand-tighten the thumb screws.

A p p e n d i x C : I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s ❖ C-11