HP LN17ps kug-ch06Page 11 Thursday, March 6, 1997 4:48 PM, Install, Flushing, Hex Dump, Front Tray, Please Wait, Please Wait, Fuser Failure, Front Tray Jam

kug-ch06 Page 11 Thursday, March 6, 1997 4:48 PM

			C o n t r o l P a n e l M e s s a g e s
Table 6.2 Control Panel messages (continued)
Message			Description/Corrective Action
Flushing...	The PostScript print job was cancelled from the Reset Menu and is being parsed
	out and discarded.
	ACTION:	None.
Formatting Disk	The hard disk is being partitioned and high level formatted.
Please Wait...	ACTION:	None.
Front Tray	Your application specifies “Manual” (or “Front Tray”) as the paper source so you
	need to load paper in the front tray.
	ACTION:	The message on the bottom line of the Control Panel display advises
		what paper size to load or feed.
Front Tray Empty	The front tray is empty.
	ACTION:	Reload the correct size of paper.
Front Tray Jam-	Paper has jammed feeding from the front tray. The message alternates with:
Remove All Paper	Open Front Cover
	Remove Jam Sheet
	ACTION:	Remove all paper from the front tray, open the front cover and pull out
		the jammed paper. Then close the front cover and reload the front
		tray. See “Front Tray Jam” (page 6-27).
Fuser Failure	The fuser assembly has failed; printing cannot resume.
Service Required	ACTION:	Cycle power on the printer. If you have just replaced the Fuser
		Cartridge, reseat it. If the problem persists, contact your dealer or
		Digital.
Hex Dump	Hex dump mode is On.
	ACTION:	None.
I/O Initializing	The Digital Network Interface Card is being initialized.
Please Wait...	ACTION:	Wait until you see the following message before taking other actions:
		Online	___
		Ready
Install	The EP (print) cartridge is missing or not installed correctly.
Print Cartridge	ACTION:	Reinstall the existing EP cartridge or install a new EP cartridge. If
		problem continues, contact your dealer or Digital.
			Table 6.2 Page 6 of 19

C h a p t e r 6 : T r o u b l e s h o o t i n g ❖ 6-11